Glo-Protek D2Rust (Direct 2 Rust) is a two part, moisture-cure, High Build, advance Acrylic Polyurethane and self-priming metallic Coating. It has a unique metallic fillers, anti-corrosive chelating agents and moisture-cure formulation in which after application, it begins to cure by pulling moisture from the molecular level as well as microscopically swelling into the individual pores of the surface as it hardens. This process along with anti-corrosive chelating agents properties seals the surface against the penetration of air, moisture, or minerals on the subtract which causes further corrosion.
Glo-Protek D2Rust (Direct 2 Rust) is an excellent self-priming finish coat on a variety of substrates such as steel, aluminum, coated metal, asbestos sheet, glass fiber reinforced polyester, wood etc.
Glo-Protek D2Rust(Direct 2 Rust) can be over coated on any paint (Enamel-Epoxy-PU) to give extra strength and enhance the life of the metal.
Application Method
- Remove loose rust scales, flaking rust, old paint, oil or grease and dirt from the corroded metal surface by appropriate manner.
- D2Rust does not require different steps of surface preparation of the metal like sand blasting, phosphating or red-oxide coating, etc.
- D2Rust can be applied by using brush, roller or spray.
- Mix the Base and Adduct as per the ratio (4:1).
- Apply an initial coat of D2Rust and allow it to dry.
- Apply a second coat at 2 to 6 hrs. Interval and maintain a minimum DFT 120 to 160 microns.
- Now the surface is ready for the over coat. The surface treated with D2Rust is compatible to any type of top coat such as Epoxy, PU, Enamel, etc.
